Some shots differ a bit  from the current version of the model. They will be replaced.
Mark the bolt positions on the root rib	File out small notches. Check for correct location.
Join the halves, drill 5 mm holes (support equally wing tips) Insert Alu tubes 5/4, glue in position.	Draw the pattern with ball point pen, cut out w. sharp knife
Soak with epoxy	Lay down, cover with adhesive tape
Remove both layers of tape when dry	Cut off the carbon/tape circles
Drill the hole for launching peg	Soak, lay down, cover with tape
The same for canopy lock	Rx-wing servo extension wire
Rudder pushrod	Elevator pushrod
Only NOW attach temporarily the wing to the pod, stab to the boom. Join the pod/wing assembly with the boom/tail assembly and carefully glue in correct position. Check the wing vs. tailplane.
	Pushrod exits
Aileron servos	Aileron servos